Does anyone know if this can be done or if what issues i might have to overcome. Are the motor mounts the same? Will everything bolt up? The engine is sideways in the continental compared to the mark. I have a mark and just found a junk continental with a 32 v 4.6. It would be nice to bring my...
can anyone explain how to pin point the reason for compression loss i know how to tell if there isn't enough compression but do not know the next step any advice would be great thanks
i recently installed a underdrive crank pully in my mark viii now the alternator isn't charging at an idle that pully is still stock do i need a bigger or smaller pully for the alternator
also if i change the idle whats the max rpm i can set it to without messing anything up
does anyone know where i can find a bushing kit for my 96 mark only need them for the rear shocks part numbers would be great poly if possible but regular will do
thanks
i replaced the t toward the back of the intake but i also noticed when the engine is running and i pull the pcv valve out of the motor it runs the same with it out i pulled the vac line off the valve then it ran like :q:q:q:q
i got a friends scanner to check the light and it said lean mixture in banks 1 and 2 also check mass air does anyone know what should be done. when crusing on the highway or even the streets its like the motor twitches . when you step on the gas theres a loss of power at lower speeds and some...
When i first got my 96 mark viii when driveing on the highway doing around 70 mph if i reset the mpg display it would show about 28 mpg and around 16 on the streets since then it has droped to 20 at the most on the highway and 13 on the street. I recently replaced plugs wires coil packs fuel...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.