Search results

Own a Lincoln LS, 2006. 132,000 miles. Has been running great for the past several years. No problems or major repairs. However, yesterday I was just driving down the road and the engine just STOPPED DEAD. All dash lights (oil, battery, engine) came on red. The engine just Stopped. I waited a...

Noise tuned out to be a bad alternator. Now I just have the traction control light displaying in the dash. And sometimes get the message on the dash of "check the power brake" Anyone have a simple check list for the traction control and power brake? Thanks,

I have lights coming on and off on all four of the above; however, have been reading the threads and believe I can fix them fairly quickly. HOWEVER, I have a whining or squealing noise coming from under the hood. The noise started about the same time as the brake and tracking systems problems...

Thanks to joegr and kumba. Good information. Going to take a little while for me to decipher your great comments. Will send a thread with my thoughts tomorrow.

Some authorities say to use ohms to test the CHT Sensor, other authorities say use volts. Which is best and/or what do you suggest. Where would you tie into the system to get your readings? I am tying into the system with my ohm meter with parallel connections with the two wires leaving the CHT...

Thanks for the quick information. Having the pin numbers will be of help to me. By the way, upon you suggestions, I have successfully taken the manifold off and I am replacing the CHT sensor and its connector wire. Never done this extensive of work on a car before. As you said, I took me about...

On my 2000 LS, 3.9L V8 and on the Engine Oil Filter Adapter (6881) there is a Engine Coolant Temperature Sensor F5AZ-12A648-AB, (Presently replaced by 3F1Z-12A648-A) screwed into the adapter. Would some one tell me where the Sensors connecting wire is connected to the engine component so...

For my 2000 LS, 3.9 liter, V-8 engine, would someone please furnish me a wiring diagram of all the engine compartment sensors ? All the connections to/from both the PCM and ECM. Additionally, if anyone has a “routing” diagram of the same components, I sure could use it. If not asking too...

Thanks for the check list. If anyone would come up with a solution to and LS question, it would be you. Over the past two years you have always offered the best solutions to any and everybody's LS problems. Again thanks for your expert LS knowledge and assistant. I will try you suggestions over...

G-RELL. The problem is not the sensor's cost and identification, it is the time and labor for me to remove the manifold to get to the CHT sensor. Everyone I have talked to tells me that it will take me three to four hours of my time and about $100.00+ in parts. Before, I go through the above...

Does anyone have a good electrical test for the Cylinder Head Temperature Sensor on a LS 2000? Volts and/or Ohms. Where would you suggest I hook up my ohm meter for testing? Do you have good "benchmark" figures you can provide me as to what I should be reading on my ohm meter?

Waited until this morning.... Got in my car and did exactly what you told me to do. On the FIRST try, the old 2000 LS turned over and is running great. GREAT, OUTSTANDING advise. Like you, I sure would like to know the philosophy behind how this service fix works. Thanks, Bill

Almost Almost started. Will wait an hour or so and try again. Thanks, will let you know how I come out.

Thanks, Thanks, I will try and get back to you....

Thanks, will try and let you know.

I have a 2000 LS. It has been setting for several months without me driving it; however, I have been starting it and running it for five to ten minutes every other week. Day before yesterday, I tried to start. It turned over and tried to start several times without a complete start; ran down...

I am converting from a GEN 1 hydraulic fan to a new electric fan in my 2000 LS. About 95% finished. The manufacturer recommends that I connect the “A/C Compressor Positive Signal” wire from their controller directly to the A/C compressor sensor on the LS. I am assuming that this is too pickup a...

Thanks, I tried a couple of links but did not find it. Your info is appreciated.

What is the total volume of antifreeze and distilled water in a 2000LS, 3.9L engine?

When is the Engine Coolant Temperature Sensor (12A648), the one that is fitted into the oil filter bracket, used and on what applications? Lincoln 2000LS, 3.9L. Mine doesn’t seam to have a pickup lead attached. And I don’t remember ever seeing it.