Search results for query: LED Bulbs

  • Before: Jun 19, 2019
  • Order by date
  1. The following words were not included in your search because they are too short, too long, or too common: LED
  1. Turboguy

    For Sale $500 Parts LS, only 120K On V-8

    120K 2001 3.9 V-8, synthetic only, have maintenance records New windshield from last year, old one got broken in hailstorm 4 newer tires with lots of tread, on factory 16 inch rims Lots of newer mechanical parts, body hailed out Alpine deck / 4 Infinity 6x9s / Kicker sub amp, worth $500 The...
  2. 0

    Moisture in headlight

    I was looking at some Gorilla sealant that dries clear and is silicon if the housing seal is bad. Is the only way to find where the leak is coming from is to fill the light with water? Cause if I can avoid putting anything else in it I may just seal the entire light to be safe.
  3. 04_Sport_LS

    Moisture in headlight

    Heat gun will be too hot. Low wattage hair dryer would be much better. Also... I think the big box home store sell a butyl type caulk. That might work better than epoxy... but will have a longer cure time. The o-rings on the bulbs usually last the life of the bulbs, so unless installed...
  4. FDR

    Moisture in headlight

    making them clear is the easy part. Polishing can make it look good if the damage isn't too deep. You may have to go with sanding from 400-1000 or 1500 to really clean them up, then followed by polishing. But it'll all be for nothing in a month or three if you don't seal it with a good clearcoat...
  5. 0

    Moisture in headlight

    I’ll have to check to see if the bulbs are sealing correctly. I’d like to get that crystal clear look out of them. Any suggestions on products to use or to buff with?
  6. J

    For Sale 1997 and 1998 HID lights

    I have three working HID assemblies with bulbs, all in working condition
  7. FDR

    Moisture in headlight

    Make sure there's no cracks and that the bulbs are sealing correctly. Otherwise, it's pretty common on Gen 1. It used a rubber butyl sealer that softens with heat. It's usually fine if applied correctly. It may be possible to reseal it by putting it in the over for 10 minutes at 210F and then...
  8. Sincoln

    Any way to disable the cell phone and SOS warnings?

    This has been on the back burner for ages as I just ignored the warnings. Recently found a new button/latch for the sunglasses case in the overhead cluster, which depending on year/model, might have the SOS lighting, Low Tire Pressure warning, map/dome lights, sunroof switch, etc. in the...
  9. FDR

    Lincoln LS Gen 1 question about upgrading to LED headlight bulbs

    Gen 1 Low beam 9006 can swap for 9012 Gen 2 low H11 can swap for H9 9005 high can swap for 9011 Those swaps bump output about 25% without changing filament position. They need a little trimming of the tabs. Philips is the preferred brand when you can't find OEM Chevy 9012 bulbs (Vosla? Vostra?)...
  10. donnie

    Lincoln LS Gen 1 question about upgrading to LED headlight bulbs

    Yes you can there is a led set up on amazon that cost a little more but they have 3 LEDs instead of 1. I used the 1 and light was everywhere blinding everyone but the one with 3 leds I haven’t had issues and you can see a line of cut off on a wall and while driving. And it’s not a perfect line...
  11. B

    Lincoln LS Gen 1 question about upgrading to LED headlight bulbs

    My fault, that was for 03-06 halogens which I replaced with an 06 LSE bumper. You can swap the H9 and H11 easily for more low beam output. I’m sure something similar could be done for Gen I halogen with some google searching H9 Headlight Bulbs Anyone?
  12. B

    Lincoln LS Gen 1 question about upgrading to LED headlight bulbs

    If better night driving is your goal I think the HID headlights from Gen II is your best bet, followed closely behind the headlamp upgrade for Halogen bulbs - this is the cheaper route but not by much, an HID at pull yards can be had for $50 a piece. I can’t remember the exact bulb number, but...
  13. 1LoudLS

    Lincoln LS Gen 1 question about upgrading to LED headlight bulbs

    ...is and also in a slightly different location that where in the bulb circuit board is the LED/s mounted. As far as getting good quality HID?LED bulbs that doesn't blind everybody on the road, some may be better than others but they all will have some about of glare/light scatter that will...
  14. DaleGrib

    Lincoln LS Gen 1 question about upgrading to LED headlight bulbs

    ...which is why I was trying to do something about the lights. I know they make good OEM quality HID conversions and they also make decent LED bulbs that don't blind everyone on the road. I am not trying to do something illegal at all. I know the big key on these LED bulbs is to buy ones that...
  15. DaleGrib

    Lincoln LS Gen 1 question about upgrading to LED headlight bulbs

    Has anyone here upgraded their headlight bulbs to LED ? And did you have issues with flicker? I am looking at upgrading my bulbs since I just purchased new headlights and I wanted to see if anyone had done this here. I was thinking of doing all the front lights in LED if it would not cause any...
  16. Best way to LED your Door entry light.

    Best way to LED your Door entry light.

    As a new Mark VIII owner, I'm coming to realize PVC cement & 3m emblem tape are both key items to hold these cars together! The plastic on my FL car is extremely frail and many of the plastic studs are gone. If you infact still have your door light lenses with original bulbs, this post is for...
  17. Gagurass

    License plate bulb socket?

    I got pulled over for a license plate bulb being out. I ordered new led bulbs and replaced both. The one that was out initially did not light up and upon further inspection I saw the old bulb was burnt and the socket looked cooked. I assumed it was a wiring problem so not wishing to deal with...
  18. joegr

    Interior LED replacement lights issue

    You have a misunderstanding of how the map lights work. With the switch in the normal position, they are directly connected to the same circuit as the rest of the interior lights.
  19. 04_Sport_LS

    Interior LED replacement lights issue

    That's it... I installed map lights at a different time. I didn't count them because they are disconnected so that they don't come on with the rest of the lights... but only when the buttons are pushed. Evidently there was enough load passing through the switches,,, to allow the old bulbs to...
  20. nghtshd88

    Interior LED replacement lights issue

    Ordered all mine from superbrightleds and dont have any that stay on except the plate bulbs.
Back
Top