Recent content by TheBigRedOne

Can you get the little short pieces of tube that fit between the elbows and the tee? One of mine cracked when I tried to remove it from the elbow. They are about an inch long.

Can you still get those molded 90 degree vacuum lines from Lincoln or Ford? I want to buy the elbows and the tee new.

Anyone have a driver's seat they would be willing to ship to me at zip code 36109? Prefer saddle but will take any color. I cant find any in my local area.

The problem is with the connectors melting from the arcing.

Yes and it was the connector that got burnt and if I reached under the dash and jiggled the wires it would work and then when I let go it would stop. You can get the harness from Ford with new connectors on both ends or you can get it with just the black connector on one end and bare wires on...

How much do you want for the fan? Dont forget I need the wire too.

I need a blower fan and the wire that connects between it and the resistor for my '97. Mine is toast. The fan terminals are burnt up.

Thanks, I found out the terminals in the blower motor are toast and I need a new fan and the wire that goes from the fan to the resistor. Any one got one they can sell me?

I'm trying to fix my intermittent blower fan problem by tightening the female terminals on the plug. How do i get the terminals out of the plastic? Do you stick the small screwdriver in from the wire side or the side that goes into the fan motor? It's really hard to get down under the dash...

Thanks

Which are better, Suncore or Westar? I've seen 2 Westars on Ebay for $116.50 and 2 Suncores for $125.00.

I caught my evap tray on a parking block and it got all mangled up. Anyone got one with canisters if possible?

Is this self test done with motor on or off? I did it both ways.

I finally did the self test and I got the following code: 030 Automatic temperature control sensor shorted. Where is this sensor located? Is it expensive?

Yes I still have both.