will this shifter work?

[aggiestckl]

will this fit? http://www.uprproducts.com/shopping/shopexd.asp?id=570

and would this work also?

http://www.uprproducts.com/shopping/shopexd.asp?id=617

i got a 1997 mark

 

[k9t8m]

will this fit? http://www.uprproducts.com/shopping/shopexd.asp?id=570

and would this work also?

http://www.uprproducts.com/shopping/shopexd.asp?id=617

i got a 1997 mark

Yes it will work, I believe there is a member here with a that same shifter know, but re-wired the o\d button 2 the traction control button, so when the traction control is disengaged, the o\d is also.

 

[bigdog1279]

wish i could change the shif nob on my 95 continetal but for starters i cant even get the dam thing off :q:q:q:q iv tried everything

 

[k9t8m]

1wykdmk8 is the Guy w\ that handle.

 

[Dern Humpus]

kinda neat, does it tell you what gear you are in?

 

[1wykdmk8]

I have the billet one instead of the black anodized one. So, yes they will work. The only thing is I am not sure what the interior looks like in the gen 2 as far as the T/C switch. If you have a T/C switch you can simply rewire the O/D button to the T/C switch as I did....instead of using the O/D button from UPR, but that switch will work as well.

Here is a pic of the shifter in my car:

 

[K*A*B]

think the button may work with the stock shifter handle
i need a nitrous button but haven't been able to come up with anything that looks halfway descent

 

[driller]

think the button may work with the stock shifter handle
i need a nitrous button but haven't been able to come up with anything that looks halfway descent

Do as Ray did with his OD & T/C switches and put the OD switch along with the T/C switch. This frees up the stock OD switch to use as a nitrous trigger thru a latching relay with a WOT switch for a safety along with an rpm window switch for launch delay. :nos:

 

[K*A*B]

i was going to use the od switch befor but i want a switch that is off when i let off
the od switch needs to be depressed again to release it
i had a window switch on it but found no need for it on this car so i took it off and sold it

 

[fossten]

I have the billet one instead of the black anodized one. So, yes they will work. The only thing is I am not sure what the interior looks like in the gen 2 as far as the T/C switch. If you have a T/C switch you can simply rewire the O/D button to the T/C switch as I did....instead of using the O/D button from UPR, but that switch will work as well.

Here is a pic of the shifter in my car:

When are you gonna put a boot or something over the rest of that stick?

Just wondering...