I'll make a cleaned up drawing when I have time and post it.
Yes they were a sleeve set up originally I didn't think it necessary
to replicate them this is my design currently untested but will
shortly be going in my 95 followed by my 97
I look forward to the completed product. I am assuming these are the front bushings. Are you aware the inner part is 2 sleeves with 1 slidding inside the other?
disclaimer this is my car and my design
sizes are taken from my factory strut rod bushing parts
your parts may vary
if there is not tolerance it cause
it really doesn't matter
the (REF) if for reference to the thickness of the factory
strut rod busing plate on that side
I haven't had time to put them in so both my cars go clunk still
If you want to make a set for someone go ahaed. I have no time
to get on the lathe right now and no garage to even put in my own parts.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.