First i want to apologize to any members who had to endure reading all my questions at the other club,and thank the members who had helped. here is where I am stuck at: I got the maf out, i got a custom adapter, i uncorked and plugged the throttle tube and painted,got a 3" cone filter, got the asst.nuts and bolts, and got it pretty much mocked up for finished install. here are the probs i am having, i need some sort of adapter to fit the maf so i can clamp the maf to the stock rubber piece on the throttle tube, Driller gave me a great idea,using vulcanized rubber tape to make it fit, but suggested i only use it as temporary, tiffany,had pieces apparantly from a mustang but it had an adapter of some sort,LMS seems to have the piece included in their kit,but I am not upgrading the MAF at this time, i need some suggestions, i dont want to spend 150-200 on a cold air kit for a mustang for one piece, so i need some help, I also need some help about making a heat shield, i don't have any metal or any fabricating tools here so i am limited, i was going to use leos idea and just custom the stock box, but the maf sits loose inthere, i may use the idea of rubber tape to snug it in. what do you guys think? all help will be used and appreciated Jeff :L