Info on what parts names are and where they go!!!

[97SilverLSCcobra]

Does anyone have any idea what the name of this part is and where it gets mounted to? I found where it plugs into my harness at but I don't know where it gets mounted at! Are there two of them?
Thanks,
Daniel

 

[LaserSVT]

Coil packs noise supressor.
Mounts to the back of the heads. One for each side.

 

[97SilverLSCcobra]

Coil packs noise supressor.
Mounts to the back of the heads. One for each side.

Appreciated!

Do you know whether the Gen 1 and Gen 2's have different plugs on the o2 sensors? Plus I need to figure out where all I need to put my grounds on my engine because they were'nt hanging from the engine when I got it and they are not attatched anywhere on the chassis! Also, what can I use if I don't have the flat looking ground straps! Note, I already have the ground that goes from the battery to the front of the timing cover, the one on the on the main harness!

 

[DieselDan]

A gen 2 is OBD 2, depending on what gear gen 1 the donor is, it is probably OBD 1. A OBD 1 car will only have 2 O2 sensors, a gen 2 will have 4.

 

[LaserSVT]

And to answer the question, the O2s are the same.

You can use 4awg wire, thats what I use for my grounds. One goes from the battery to the drivers side engine mount and the passenger side has one that goes from the wheel well to the passenger motor mount.

 

[97SilverLSCcobra]

Alrighty I got ya! Preciate it! Oh I asked about the o2 sensors because I am under the car trying to plug in the o2 sensor into the harness and it will not go in so I looked at them and they have the little plastic guides at different angles, both sides? So it will not let them plug in! The manifolds with the o2 sensors in them are from a '93 and the car is a '97 LSC! I will take a few pics in the morning and post them up here! The car is not at my house or else I would do it right now! But I appreciate ya'll!!!