Frankencougie
Active LVC Member
It's hot in the ATL right now so any work is best done when the sun goes down. I took charge of a CE from a lady at work who was slammed/jacked tonight after work and started to tear into it at 10pm. I got all the way to the last corner and the LCA bolt was stuck. I have a small sledge and a axe that I broke and use for pounding stuff like this. I hit it a couple times then did a Deep Creep soak and tried again but I doubt its very neighborly to be doing this at 3am. The sun will be an issue so I hope I can get it loose and the coil/spring in before it's 90 degrees again.
There may be a flame wrench added to mix if the tonight's soak is for naught.
Grrrr.
There may be a flame wrench added to mix if the tonight's soak is for naught.
Grrrr.