Search results for query: *

Here is the problem I'm having on my 98 lsc. If I unlock the car with my factory remote all interior lighting works as it should. If I use keyless entry pad on drivers door, or the thumb switch on dash,again,all lights work as they should. Problem is, if I open either drivers or passenger door...

Does anyone out there have an extra blend door actuator lever they would like to part with? Dealer say's they are no longer available from ford.Thanks!

Has anyone out there replaced the hood latch release cable on a gen 2? Are they even still available from ford at this point,looks like this can be a real pita to fix! Thanks

Can anybody give me a ballpark idea on ho long it would take to change out a nuetral switch on a gen 2? Been a while and cant remember how much room is under there.

Ive got a 98 lsc which I swapped another motor into about a year ago,at which time I replaced just about everything in the car,including a new starter. I have only put about a thousand miles on it and up till now 0 problems.Today drove it 20 miles or so,got to where I was going,still running...

Does anyone know if the clockspring out of a 2001 grand marquie will work on a 98 mark?My local bone yard just got the merc in yesterday,low miles and it hasnt been picked over too bad yet,Thanks

Hi everybody,I've got my 98 up on stands to do some maintianance and was thinking about fabing up some k-member braces for it.My question is do I need to take any certain precautions,other than disconecting the battary, before welding my brackets to the sub frame as to not fry any electrical...

Hey everybody,quick question,I'm getting ready to do a filter change on the trans in my '98 lsc and was wondering if there is any particular brand of trans fluid you guy's recomend over the others.It's a stock trans with over 160,000 miles on it,still shifts,and runs fine just time for a filter...

I have a 98 gen 2 and what I need is the small metal "arm" that is held onto the door lock/tumbler assembly with a circlip.I wish I could post a picture but I don't have one to photograph.There is a rod that goes from the door latch assembly up to the lock at the door handle,this "arm" is what...

I'm in the prosess of putting my gen 2 back together,and I might have a problem.Engine and trans are back in and it sounds great however I did not have the rag joint bolted to the rack yet,here's the problem,my 9 year old got in the car yesterday while I was cleaning up the shop and decided to...

Hi everyone,I'm in the middle of restoring my '98 and was doing some work on my interior today and noticed that some of the letters on my shifter werent lighting up,no big deal,but since the console was already out I thought I would take care of this to.Heres the problem,trying to explain what I...

Hi everybody,I'm in the prosess of putting my gen 2 back together and ran into a snag.My question is,between the wind shield and the hood you have the two vent panels(where the windshield washers are)beneath the drivers side panel is the wiper transmision assembly,O.K. now on the passenger side...

I was wondering if there is any other location to install an oil pressure sending unit other than the filter housing on our motors? I noticed allen plugs on each head which I'm assuming are oil passages,would this work,and if so would my readings be accurate?Any advice would be greatly...

I have some parts off a 96 lsc I wont be needing,I have a good set of imrc plates,just need to be cleaned up,I'd like to get 250.00 for,I also have a complete set of hid's for a 96,lenses,all bulbs,including low beams,and ballasts.Pass. side lens has some water marks on chrome and driver side...

Will a gen 1 k-member and a gen 1 fuel tank(including fuel pump from a gen 1) bolt into a gen 2? Thanks in advance

went to start my 98 mark a while back,started right up,ran for about 5 seconds then just died,no pop's,bangs,or noises of any kind,just like I shut off the key.When I tried to restart it she turned over real slow and the starter sounded like it was really working hard.I checked the battery and...

Can anyone tell me if the blend door parts for a gen 2 are still available from the dealers,and if so whats a ballpark price on the motor and actuator? Thanks in advance.

Hi everyone,I've searched past threads on this and found some great info but nothing really specific to my problem.I have a '98 lsc with about 150 thousand on her,last week I took it out for it's last drive before winter storage,ran great.The next morning went to pull it in my shop,it started...