Recent content by LSC91

Ok guys please give me some guidance. I've got a 92 lsc. As of right now I have a cold air intake along with a mass air install and swapped out the alternator to a 130 amp. I did this because I was taking out my smog pump and the lower ear on the bracket broke. I bought a mustang brake which is...

ok so I have been looking and searching for the install of these wheels. Im not sure I want to switch to the sn95 spindles so how did you go about getting these to fit on the stock front rotors. Do you grind the inside of the wheel, grind the hub, or spacer it. Thanks in advance.

Does anyone know what the belt size is when deletingthe smog and you have an underdrive crank pulley

Can you tell me how to pull the codes with a paper clip? I don't have a problem getting spending $25 on a scanner either. If you can tell were and what to buy it would be greatly appreciated, but for the mean time I will use a paper clip until Friday to buy the scanner.

The only problem I have with pulling codes is It doesn't alway have the problem. It's not setting a light or anything like that. The other problem I have is that the scan tools I have access to are not able to read code off of the car. Someone told me what type of scanner to buy but I can't...

Well I drive a 91 MRK Vii and it just recently started to sputter and miss. The plugs, cap, rotor, wires, and fuel filter were change about a year ago but I just cleaned the t/b, egr, egr spacer and ran a fuel injection machine on the car 2 weeks ago and its still running like :q:q:q:q. I really...

I thought I read somewhere about a aerostars drive shaft fitting into the mark Vii. does anyone how true it is.

The original one are metal and come out the back to but what I would like to see is how they look around the axle and out the back. Are they 1 piece or 2 piece,do they have small chrome tips or are they long .

Does anyone have a close up picture if them. I would like to see what they look like.

Hey while at the nmra's saturday I had a chance to talk to a rep. for pypes exhaust. He says if 1000 people buy sets of 2.5 tail pipes they will manufacture them. Is anyone interested in putting an ored together.

hey I was wondering if anyone has any old control arms laying around. I'm looking for a set to put bushings in because mine are starting to go and I don't want to be changing air bags anytime in the near future.

hey I was wondering if anyone has any old rear control arms laying around. I'm looking for a set to put bushings in because mine are starting to go and I don't want to be ghanging air bags anytime in the near future.

For some stupid reason I can't get on that site at my work, but is that the tech article about cleaning the board. I haven't tried this yet but I wasn't sure if that was my problem or not

Anyone know what could cause the message center to beep for the dte. Also over the week end it started to flash on and off, it still beeps when I fire the car up and I have to hit any of the buttons to shut the beeping off. Its kind of annoying so if anyone can help please do. Thank you.

One of these time i would like to get up there and watch some racing at that track.