jmtiseo
The Peanut Gallery
Hey there gang. As mentioned in another thread I broke the clip/connection for the wire harness to the VAPS Actuator Assembly while removing my steering gear. Did not come across a thread pertaining to it but I can't believe this is a first. Reason being, the thing was hidden from sight until I went to put it back in and found a dangling wire and connection.
Has anyone replaced this on their vehicle? If so, can it be done without removing the steering gear? Would I need to refill and bleed the steering gear again?
Part number 4Z-3N803-AA is shown and circled below. The only good thing this part has going for it is that it can be replaced without replacing the entire steering gear assembly, saving a whopping $800. Going to be an interesting drive in the morning.
Has anyone replaced this on their vehicle? If so, can it be done without removing the steering gear? Would I need to refill and bleed the steering gear again?
Part number 4Z-3N803-AA is shown and circled below. The only good thing this part has going for it is that it can be replaced without replacing the entire steering gear assembly, saving a whopping $800. Going to be an interesting drive in the morning.