Turn Light Replacement

Joe O

LVC Member
Joined
Dec 31, 2005
Messages
35
Reaction score
0
Location
Narvon
The bulb is burned out on turning light. Found one attachment under the headlight adjusting panel. Suspect I have to pull fender liner to get to the rest. Am I correct?

Thanks,

Joe
 
He is correct. to get to the nut on the inside just open the little flap and its on the side closes to the light housing. the screw is as the very back of the just under the last bit of the chrome trim. its like that for all gen 1 cars i beleive.
 
The bulb is burned out on turning light. Found one attachment under the headlight adjusting panel. Suspect I have to pull fender liner to get to the rest. Am I correct?

Thanks,

Joe

Remove screw from light on the outer lower corner by the bottom of orange part, remove 11mm? nut from access hole in rad cover, carefully pull light away enough to slide out of the eyebrow trim, unplug connector, change bulb(s) and reverse process.
 
Remove screw from light on the outer lower corner by the bottom of orange part, remove 11mm? nut from access hole in rad cover, carefully pull light away enough to slide out of the eyebrow trim, unplug connector, change bulb(s) and reverse process.

Thanks for the help. I can now see where I am turning! Didn't know about the little screw hiding in the back. Thought I'd have to get under the fender liner. Now the only problem I have is to see where I am going when driving at night. Know of any headlight improvements?

Joe
 
Thanks for the help. I can now see where I am turning! Didn't know about the little screw hiding in the back. Thought I'd have to get under the fender liner. Now the only problem I have is to see where I am going when driving at night. Know of any headlight improvements?

Joe

http://annarbor.craigslist.org/pts/3993990222.html

See if these are still availible if your chrome I'd shot and ask the guy condition(they look new) and if he ships .

Then buy an hid kit for them
 

Members online

No members online now.
Back
Top