Ray-switch not venting in high humidity weather

[Stangman]

Replaced my drivers side air strut, and a bunch of other bushings at the same time, and wanted to test the ray switch for giggles, but the car wouldn't drop. And now that I think about, it also wouldn't reset the compressor when I first started the car... anyone got any ideas? Im going to check my wiring connections tonight.

I don't know enough about the vents and solenoids, etc to know where to look first

I know I probably have 2 different issues going on here. Any input appreciated

 

[LaserSVT]

Turn the air ride switch back on.

 

[Stangman]

It was on... that's what I couldn't understand. I had just used the switch about a week ago to reset the compressor

 

[ford nut]

Does the car vent at all?
If you turn off the ray switch does it act normal..drop at speed...go to curb height when you close the door?
If no I would wonder if the vent solenoid in the compressor is stuck "common problem"
If you wired in the switch, and it worked I doubt it would be the switch.