New photoshoot Teaser...

[JVIP]

Those are noice...

I dont get it.....

Welcome to LVC.:W:V

Nothing wrong with shaking things up with an "original" introduction. At least, you didn't try to sell it. Unlike a few low-life former members. But that is another story.

The photoshop is where you plan to go with it. Good look for the LS. Love to see it happen. What other plans do you have for it?

Yea...I hit up your thread on VIPSTYLE forum.....yea this is were the cars going to go, Ive been studying the cars over there to perfect my idea.......
Im trying to find a good balance,,,the hardest part is going to be the offset and rims to fit the ls and its lines.

LSVIPDEMON/JWerner in the heezy.

Hummmm dont get this either....

 

[NYC LS8]

You wouldn't since you're new here.

 

[RollinLS]

Yea...I hit up your thread on VIPSTYLE forum.....yea this is were the cars going to go, Ive been studying the cars over there to perfect my idea.......
Im trying to find a good balance,,,the hardest part is going to be the offset and rims to fit the ls and its lines.

I haven't been there for awhile. The two new cars and other projects have kept me busy.

 

[Missing Linc']

lsvipdemon/jwerner in the heezy.

bs

 

[JVIP]

Had to bring this back to life....

Been working with some ideas lets see what you think...

I'll be going with either the wings west or Jt kit which give a nice surface to work with...Ill be getting rid of the exhaust holes and moving them to the middle of the bumper...

Heres the inspiration ill be going for with the exhaust, I just think it would look so hot, notice the silver at the bottom of the bumper, that's the exhaust tips/

http://i60.photobucket.com/albums/h14/natedawg9640/osv6.jpg

This is about as close as Ive found, and I think it fits perfect..

http://www.summitracing.com/parts/FLO-15302/?rtype=10

or two of these together,flush mounted to the bumper in the middle lower portion of the bumper

http://www.summitracing.com/parts/JEX-PCAM214SS/?rtype=10

 

[manoli]

That should be very intresting.

 

[SlickLS]

Well the spare tire well is in the middle so you would prolly have to eliminate that to get the exhaust to come out in the middle. Nice ideas though

 

[JVIP]

Ive looked at i a couple of times and what I have come up with is should be able to notch the spare tire area allowing for the pipes to run into the area for the tips....

This would allow me to keep the spare tire in its spot and run the set up.