TheBigL'sLS
LVC Member
Hey, what's up guys? I just got a sub and amp and want to install it myself but am basically clueless about audio-anything. Here's what I bought:
Power Acoustik Plasma TS1440-2
Amplifier Type: 2-channel
RMS Power @ 4 Ohms: 300W x 2
THD at 4-Ohm RMS Power: 0.02 %
Bridged RMS Power @ 4 Ohms: 720W x 1
Speaker Level Inputs: yes
Preamp Outputs: yes
Built-In Crossovers: HP/LP
Bass Boost: 0 - 18 dB
Frequency Response: 10-30,000 Hz
Signal to Noise Ratio: 98 dB
[COLOR="Red"]Kicker 1100-Watt 12" Subwoofer w/Enclosure (VS12L5) 1100 Watts peak power
550 watts RMS
Dual Voice Coil
4 ohm ( I think)[/COLOR]
What I want to do is run it to the stock head. What am I going to need for the installation? Also, I realize that the amp's RMS is 720w, and the sub's is 550w (I got a steal of a deal on the amp so just went for it). How can I make this work? What I'm looking for is basically an outline of what needs to be done. Any help would be appreciated.
Thanks in advance
Power Acoustik Plasma TS1440-2
Amplifier Type: 2-channel
RMS Power @ 4 Ohms: 300W x 2
THD at 4-Ohm RMS Power: 0.02 %
Bridged RMS Power @ 4 Ohms: 720W x 1
Speaker Level Inputs: yes
Preamp Outputs: yes
Built-In Crossovers: HP/LP
Bass Boost: 0 - 18 dB
Frequency Response: 10-30,000 Hz
Signal to Noise Ratio: 98 dB
[COLOR="Red"]Kicker 1100-Watt 12" Subwoofer w/Enclosure (VS12L5) 1100 Watts peak power
550 watts RMS
Dual Voice Coil
4 ohm ( I think)[/COLOR]
What I want to do is run it to the stock head. What am I going to need for the installation? Also, I realize that the amp's RMS is 720w, and the sub's is 550w (I got a steal of a deal on the amp so just went for it). How can I make this work? What I'm looking for is basically an outline of what needs to be done. Any help would be appreciated.
Thanks in advance