Do any of you guys have problems welding it. I read that somewhere who knows if its true. I know true stainless is a bitch to weld with out a tig torch.
The LS exhaust is stainless......... HOWEVER, there is stainless and then again there is stainless. The LS exhaust isn't a high quality stainless steel.
Carbon wire and 75/25 gas will work. I did mine that way with no issues. If this was a structural weld then I'd say its not the correct way to weld but this low pressure, non-structural situation should be fine.
Ditto, the car's exhaust is some form of 409 stainless. It'll rust and discolor some but not nearly as bad as aluminized steel tubing. Welding it is simple enough with a Mig and mix gas.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.