Dashboard removal

[Kstills]

I'm pulling the dash out of my parts car.

I've taken out all the bolts from the blend door fix thread. Steering column is out, center stack has been taken out, I found the thread for taking off the shifter, so that won't be a problem now. I spent 2 hours under the dash looking for and removing all the clips into the wiring harness that I could.

Question is, once the bolts are out (from the blend door fix) and the steering column is out, are there any other bolts that I need to remove, or is it just taking apart the wiring harness?

 

[BAD97LSC]

after that its all harness. there are a few small bolts around the right side of the stereo opening that are harness ground bolts, little 8 mm bolts and a few that hold the lamp out module on the top of the glove box opening other than that its all harness, and it sucks too, just be gentle!

 

[jrherald420]

All the wiring is what makes it sh*tty to do.

 

[Kstills]

Ok, thanks for the replys.

I agree, those wires are a pita, and my hands are all f'ed up from being inside the dash. But it's good to know that it's just a matter of tracing them back and undoing the clips.

One thing I have is time.

Once I get the dash out (and pull the wires for the CD changer) it's on to the engine.