CobraMark'95 Project

MrWilson

MrWilson

Dedicated LVC Member
Joined
Dec 21, 2004
Messages
3,115
Reaction score
2
Location
NJ
I have been toying with many ideas over the past year or so, as everybody knows. Today i have set the foundation for the CobraMark'95 Project. Its gone from 5.2 Stroker naturally aspirated, to Turbo/TT on the stocker 4.6, Turbo on a built up 4.6. Building up the mark motor and supercharging it. Or a direct s/c Cobra swap. After researching each option extensivly and figguring out which would be most economical (price and timewise) for me, i have decided on a s/c Cobra swap. The whole motor i can buy from my local ford dealer for $3750+tax. that comes out 3k less than anything else iv priced out (just talking about the motor itself now). The scheduel for the project: By the end of august have the hood, wing, exhaust, gears, and paint.

September: bring home the Cobra motor, and start pulling the factory QC(quad cam)

That is as far as i want to predict as of now. This mark is going to be a wonderful project. If your in the area and you want to chip in some help when things start to realy heat up, i can make a killer grilled cheese :)

Today I set forth the goals, lets see how well i can hit them, shall we?
 
Good luck Andy, this should be an interesting project are you going to post pics during the course of the project ?
 
yes andy as peppermans side kik i would like to see more pics of this most unique project thats will flash the pages of lvc.
 
pepperman said:
Good luck Andy, this should be an interesting project are you going to post pics during the course of the project ?
Click to expand...

Are you kidding, of course i will. So many posts of pics it will make me look like your post pimp.
 
Good luck getting the 03-04 Cobra 4.6 DOHC complete motor for $3750 especially from dealer.

Do some more research buddy, most cost effective and least problematic will be forging your bottom end and using a vortech supercharger.
 
.Don't forget to take a picture of the LED lights you installed on the trunk.
 
m_maker said:
Good luck getting the 03-04 Cobra 4.6 DOHC complete motor for $3750 especially from dealer.

Do some more research buddy, most cost effective and least problematic will be forging your bottom end and using a vortech supercharger.
Click to expand...

i have the invoice in my hand.

Calabrio said:
.Don't forget to take a picture of the LED lights you installed on the trunk.
Click to expand...
gimme 5 min...
...go check my new thread.
 
I suggest you buy 5 of them while you're at it. This price is unheard of.

Did you look into using the EEC IV to control it ?
 
m_maker said:
I suggest you buy 5 of them while you're at it. This price is unheard of.

Did you look into using the EEC IV to control it ?
Click to expand...

i have not figgured out the electronics yet...but im told i can use the mark8's eec to control the motor.
 
mr wilson any prgree yet and whats the invoice looking like for that motor?
 
Mr. Wilson sold his Mark VIII and you can't buy an 03/04 Cobra engine new for that price or anywhere near that price...
 
good point well then why did he lie about doing the whole project?
 
You must log in or register to reply here.

Members online

Total: 345 (members: 1, guests: 344)
Back
Top