Can't wait until Sunday

[Screw-Rice]

Just got off the phone with Max, my gear swap kit should be here by Friday. Dropping the car off Sunday morning to gear my 4.10's installed. I might even have to start a progress thread, like some of the other guys here...even though I don't have a lot done just yet.

Should be picking up my one piece driveshaft this week too. Sunday afternoon is going to be a lot of fun.

So by next week I should have all the following installed.
-Slotted/cross drilled rotors, already done
-SCT tune, already is done
-J-mod, trans service, likely do it this weekend
-4.10's, trak-lok, one piece shaft Sunday

Should have had wheels too, but I got screwed on the deal, and fighting to get my money back.

 

[Kraze]

Sorry to hear about the wheels, but I'm sure you'll have a smile on your face after the gears are done and you drive it! How much did the gear swap kit and trak-lok set you back total?

 

[Screw-Rice]

From Max, I spent a total of like $115, and that includes shipping. That is all the bearings, correct speedo gear, and a bottle of friction modifier.

Trac-lok I got off one of my Mustang sites from a cobra with low miles for $50. Gear I bought from a local guy for $75, and they are brand new, never installed. He decided he wanted 4.30's instead.

So far I have about $240 into my gear swap.

 

[Lux]

Nice, im also in the process of doing the same. Doing the JMOD thursday, and Getting 4.10's, aftermarket DS, and some more goodies shortly after.

Cant wait.

 

[LaserSVT]

From Max, I spent a total of like $115, and that includes shipping. That is all the bearings, correct speedo gear, and a bottle of friction modifier.

Trac-lok I got off one of my Mustang sites from a cobra with low miles for $50. Gear I bought from a local guy for $75, and they are brand new, never installed. He decided he wanted 4.30's instead.

So far I have about $240 into my gear swap.

I am in mine about the exact same cost wise. I also go Sunday (I hope, damn youz Jeff! ) to get mine installed. Ill be helping him do it though and while hes setting up the gears I will be installing the 255lph pump. Pretty sure mine is dying.

 

[Screw-Rice]

I wanted to do a pump too at the same time, but had a great deal on a set of wheels pop up. That sure bit me in the ass nice and hard.

 

[LaserSVT]

Since you are there you may as well do it. Pumps are cheap.

 

[Screw-Rice]

True. I have a boost a pump, I was going to run. Only ran it for about a week on my bird. So it's virtually new. Wonder if it would help take some of the load off the pump.