Ok so I did some calculations and turns out that a lower grille can be made with a 3ft wide mesh cutting it diagonally. Since no one besides ls4me has joined in, maybe lincoln leubbe, to you to, each piece of mesh will be cut,if they agree to cut them like this, 9'' wide and the length of it turns out to be 50'' long. The bottom grille length is roughly 42'', the length of the grille is about 27'' and around 7'' from top to bottom. The lower grille opening for a reg LS is 42''x5.5'', I measure the cdc mesh for the bottom piece for the lse bumper and it is 38''x7.5''. With this 9''x50'' piece of mesh you can do any of the 3, grille, LS lower grille, or LSE lower grille. There will be a 18 9''x50'' pieces and 2 smaller pieces left over big enough for a grille. If everyone get 2 of the big pieces, that is 9 people we can have. If not, I wouldn't mind getting the extras.