myfirstls
Active LVC Member
Hello guys. I just finish my front suspension overhaul and install pretty much everything new since my upper ball-joint, tie-rod and sway-bar link with usual rubber boot problem. While I'm at it, I replaced front bearing carrier/hub with Raybestos one. http://www.amazon.com/gp/product/B002M5KCV8/ref=oh_aui_detailpage_o03_s01?ie=UTF8&psc=1
To make the long story short, I now have ABS light on, but no code is store when I connect the code reader. I haven't driven the car due to alignment not done yet.
Could the brand new hub have bad sensor? Anything I should look for? It got dark, so I haven't play with the connector yet. I'll try unplug it and plug it back tomorrow.
To make the long story short, I now have ABS light on, but no code is store when I connect the code reader. I haven't driven the car due to alignment not done yet.
Could the brand new hub have bad sensor? Anything I should look for? It got dark, so I haven't play with the connector yet. I'll try unplug it and plug it back tomorrow.