Recent content by warthog5

Hmmmmm! Sounds like some dumb ass jewelry? I bet the money spent on that would buy a nice Snow Blower. IE: Something actually useful.

It gets cold here too. Now I gotta do this job. :( Like I don't have enough other stuff to fix around here.

I have followed this thread off & on. I hear what your saying about the flowing lines. :) My concern is the side pods. These are hard to see on the Black car that has had pix's posted. I want a flair to act as a mud flap effect where the body rolls in below the side molding. Is this...

Thank You. I was offered a deal on a complete seat track setup. EDIT: It has a broken GND wire at the large connector at the back of the seat. That is the problem. But it is broken clean and even with the connector. At this point I got the seat moved back. When looking at it previously, it...

Will a '94 seat track fit a '98 correctly?

It quit in the forward most position. It worked a few times that day when I was putting a cooler in the back seat and it did it's auto forward. This is on a '98 LSC. I didn't even notice it hadn't come back again, until I went to give this long legged gal a ride home late that night. Her...

Amen! After replacing mine and 3000mi latter the Moog stuff was ripped. Now I need to put the OEM Lincoln stuff in. It wasn't cheap for the parts. This was just the forward bushings. Aprox $180. OUCH!

Do you have brakes on the trailer on both axles? If not it's a damn good investment.

I don't put Dayco anything on Anything.

If you do any searches on PepBoys you will see that they have Lousy service. I bought some tires for my truck from them. [Best Price] Well Best Price wasn't the best deal. I needed a tire fixed once. It took them 1.5hrs of training session to get it back. They rotated and rebalanced them...

I just went thru this. Gates belt change and idler pulley. Has less than 3000mi on it and squeak-squeak-squeak. It was embarrassing sitting at a stop light. So I buy and install the tensioner pulley. Still squeaked. I spray a little laq. thinner on the belt. It quieted right up for about...

Clean Ride. :)

Have used Firefox for years.

Looked like a real PAIN doing this on the ground in a gravel driveway. :( Had you given any thought to using a true 2part epoxy paint? You could have put it back on 24hrs latter and it's tuff stuff.

Spray the heck out of it with WD-40 and open and close it. I had mine stick in the full up position. I removed the sensor's from the lower ball mount and compressed them 1/2way. I used a clamp to hold them in that position. I then turned the key on and they vented and lowered the car...