IT was involved in collision so the headlights are broken. The actuator works I didn't know how to remove it so it is still in the car. It has a brand new transmission with less than 10000 miles on it and the engine sounds very good.
I'm looking to buy a few things and wondering if anyone has part outs.
2000 3.9 tan interior
I need:
The passenger air vent and little vent above
The center counsel trim piece that hold the buttons
I am looking to buy:
ss break lines
K&N intake
If you know anyone looking to...
i'm looking to get a gen two and upgrading from the gen one
what are the common problems with gen two?
i searched but didn't find a post on it ... I'm sure its out there
My guess would be coilpacks for the shudder,
and....
A broken window regulator in the door.
I have a gen one and the door panels are easy to remove just find all the screws and give it a little muscle.
Both extremely common and should pretty much be expected to happen. Just...
I was changing them one at a time for a while and was using OEM plugs. I decided to do them all when I had to replace my valve gasket and I went with, i know not recommended, a brand from Amazon. the cost was outrageously low and concerning at the time.
I have had no problems with failure...
I hope you didn't cut the factor harness!
I recently did mine and used the schosche fdk13b harness which I ordered from Amazon.
This worked perfectly. You can call Schosche and verify the harness you need for you specific make. This will make the install very easy.
The fan seems to be spinning properly.
I did the bleeding process as good as I could with no climate control and this seems to have fixed my problem..... For now.
I have the climate control on its way and am going to replace cooling system components soon.
Are you from wi 209?
I have a 2000 lincoln ls v8 and it has been recently overheating. I also recently fried my climate control somehow when installing my new head unit. I was wondering if theses issues are possibly related.
Although the car briefly overheated before this but soon rectified itself. My gut is...
I have been trying to install the PAC SOEM-t line output converter into my factory stereo for too long.
I have a 2000,3.9 lS with alpine system and factory amp.
I have had no luck and cannot find any answers that will work. Will this loc work for my application or is the input capacity to low...
I have just got my engine back to running well after multiple misfires and a lot of frustration. I will look into the Purple Power. I plan to do my Induction system this weekend along with the plug alignment. I will need the heat shied shortly. I also plan to get the Magna Flow but that wont be...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.