Thanks. I should have mentioned that the fluid smells like it does in the bottle. No burnt smell or discoloration. Fluid level is good too. Doesn't appear to be leaking anywhere.
97 Mark viii base.
This happened while on the freeway today. Driving at 80mph. Took my foot off the gas. Normally the rpm falls to about idle, but this time it's like the transmission was down shifting. With my foot off the gas, the engine revved to about 3k and the Trans was engaged so...
Also it appears I need a "relay harness" because the car has auto-magic headlights. Is this correct? Their harness costs $22. Whatever. I just want to make sure I get everything I need.
My passenger side low beam burned out. It's the original 9500 HID bulb. Dang it.
High beam still works.
So here I am looking for a conversion kit. I've read reviews of Xentec and Kensun kits. People seem to like Kensun better.
And I think I need a 9006 HID kit for this car. Kensun...
Ok I got it turned over. It's funny that on the washer it says, "THIS SIDE OUT". Of course I ignored that the first time.
I did put the other side on correctly though. :) How does this look?
So I just replaced my SRBs and figured I'd post a pic. Does this look weird to anyone? It seems like it's taller than most of the ones I've seen. I torqued everything to spec though.
dang all of you have really nice cars! I'm not going to post a pic of mine cuz it's just ugly in comparison. That's not to say anything bad about it. ;) It just wouldn't win a beauty contest next to these other cars.
I like the one just above with the tractor in the background. One of...
I went and looked under the car again, and that is exactly what my car looks like!
I've also got oil all over the K-member, the oil pan is covered in it, and the transmission pan. I'm going to start by replacing my valve cover gaskets. And maybe the oil pan gasket. But I understand both of...
I know I need to change the valve cover gaskets because there's oil accumulating in the spark plug holes and a little bit of seepage from the valve covers directly. The K-member has oil all over it, and I occasionally smell burning oil when I get out of the car. So something is dripping onto...
I just did this job over the weekend. Dang. The car had the original sleeves, and I had to cut them out with an angle grinder because they wouldn't separate. They were riveted.
The torque spec for the front strut rod is somewhere in the range of 100 ft-lb, but the scary thing was that when I...
I just did this job on my 97 Mark this past weekend, and it was a PAIN. To replace the front strut rod bushings I had to cut out the original sleeve with an angle grinder because it's 1 piece (seemed like the sleeve was rivited on the front side). I don't know if all the Marks came that way...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.