Recent content by DuKeNoMaD

Did you replace the sway bar to frame bushings? That's where my front end clunk was coming from.

The cut coils I removed had red tags, not sure but I think the ones from the wrecker were green. And the V6 car was a base V6 2002 mine is a 2000 with no special options like sst. But came with the glovebox 6 disc changer. So idk. And yes the lower control arms in the front were loosened when I...

Have noticed my car rides lower than most after changing out my cut coils and factory shocks to a set I grabbed from a V6 at the wrecker...are the V6 springs a lower spring rate?

Awesome! I need a passenger side one..too bad no no coil covers

Now if only they had the gen 1

Your on the right route, my ls came originally with the rear sub and amp but was long gone by the time I came upon it, I tried for a while to pin out the proper lines to have a factory style amp. Only success I had was using the old harness for a remote turn on but even that was problematic as...

A small (300w) 2 ch sub amp for the rear 6x9 subs is more than enough, and as for the door speakers, running another 4 ch amp you won't see much improvement over your already high quality head unit. As for why it cuts out now the 3 ohm subs u used should actually reduce the strain on the...

Huh?. How so. The ball joint if installed correctly won't have any play, and 1 inch lower is within the normal suspension cycle.

For your application the Hayden unit should do just fine...and for about half the price of a flex-a-lite. I replaced the hyd cooling fan in my 00 V8 with one and it's been working flawlessly for over a month now

I went the universal Hayden 16" fan and controller route... grafted the electric fan motor in to the original shroud. Had no luck with the aftermarket fan controller so Wired it up with a relay to come on with ignition. Haven't had one cooling issue since...and have had no issues with major...

Ok so I have a cyl 7 missfire for a while now, only pops up after a bit if a drive (new plugs and coils so not that) and of course have a bank 1 rich/bank 2 lean that goes with it..but now an having a high rpm miss/starving issue (4500-5000 and up) looking thru forscan and my fuel syst I have...

Finished my halos

There on and look gooooood

Picked up these clean 18's.. ordered 3mm spacers...just need tires now

Filter looks right if it's the one shown in second picture. Injectors im not sure¯\_(ツ)_/¯