Module VIII failure?

[unity]

Well something is up. My car is suddenly riding high. It pumps up and vents, but even set to "slam" its almost looking like a 4X4. And if I try to raise it up, i get nothing. All sensors are good and auto leveling works fine. Vents when parks, etc.

Might have to remove it to make sure its not the air-ride computer. Sigh.

 

[LaserSVT]

My asham acts like that if the display seperates from the connecter...... oh, you have a Module8. Sorry, no clue.

 

[KC96LSC]

Does your check air ride come on?

 

[XLRVIII]

new sig file quote??

Sorry, no clue.

 

[LaserSVT]

new sig file quote??

I can count to potato!

 

[unity]

Does your check air ride come on?

Um... no. Did you read my post?

Maybe if I wait long enough, it will just go away.

 

[Icarus]

It's connected via t-taps right? I'd check them if so, they can casue some great gremlins in cars if not making a good contact.
If it doesn't use them, I'd still suggest checking all connections, wiggling etc, to make sure they're good.
Any way to reset the module?

 

[KC96LSC]

Um... no. Did you read my post?

Maybe if I wait long enough, it will just go away.

Yea! I read your post. You didn't mention if it did or didn't

I've learned not to assume anything.

All I was going to say was that I had a similar issue with mine and it was one of the connections to the level adjustment controller. It looked like it was connected but if I wiggled it, it would start to work again. I did a re-solider and haven't had a problem sense.

Good luck!

 

[unity]

I checked those unreliable taps, they look ok. But when I have time (this weekend) I will pull them and put new ones on or even solder. I have front brakes to put on and a new air intake box, so it will be an all car weekend!

I will check the dial too - which is covered in hot glue... that will not be fun to inspect.

 

[Icarus]

Yes, could be the dial too

 

[KC96LSC]

Best of luck!!!