What mufflers?

[ONEBADMK8]

No there is a small black "Loop" retainer near the front. How often and when have you ever seen a driveshaft break, sepecially in a low power car. I had a STOCK 318 Mopar shaft in the Satallite that was original with STOCK u joints. I finally tore off the rear yoke and that took 660hp on spray to do it with slicks.

 

[Don Pfau]

How often and when have you ever seen a driveshaft break, sepecially in a low power car.

I have had it happen and it leaves a lasting impression. Why are you so cranky today ??

 

[ONEBADMK8]

Not cranky at all why would you think that? I was just responding with facts and advice so people didnt go through any extra $ issues buying stuff that is not needed.

 

[KStromberg]

0:18 .... Check Engine?

Yup. Idle Air Control overspeed error more than likely as a result of retaining the Mark8 IAC when the Cobra intake swap took place. Technically I need to get a Cobra IAC. The feedback response to the PCM is probably slightly different resulting in the CEL.

 

[Icarus]

I broke the front joint in my '79 Merc. I went to show off in the parking lot in front of the mall. I came to a stop extremely quickly as I had no loop, and people swear I got air in the rear but I think that's bs (though I did get air in it two other times, lol.) Yes, I still embarrased myself good though

 

[AndyT]

We have it on sale right now for $299.99 plus a flat rate US shipping of $34.99. Its the critical component kit, comes with all needed except piping. We supply a panoramic underside hi res photo of what it looks like installed so you can get quotes and what not. Iv'e seen some shops install our kit for $200.00 and I have seen as high as $350.00. Plus we have our old ROLLED edhe razor blade tips back again!!

Lets say I get a bug up my ass, and decide to take a ride out to your shop (are you guys back up and running since that fire? I haven't been keeping track....) What would you charge me (roughly) to have your system installed on my car?

 

[Don Pfau]

Not cranky at all why would you think that? I was just responding with facts and advice so people didnt go through any extra $ issues buying stuff that is not needed.

What extra cost or issues ?? Its a excellent performance exhaust that is also inexpensive, with a plus in that it conveniently helps keep the drive shaft contained ???

 

[ONEBADMK8]

Lets say I get a bug up my ass, and decide to take a ride out to your shop (are you guys back up and running since that fire? I haven't been keeping track....) What would you charge me (roughly) to have your system installed on my car?

Yes we use our Manufacturers facility while we are in transition right in Egg Harbor City NJ. The installed cost includes polyurethane bushed hardened galvinized steel hangers, galvinized 2.5 inch piping, the xx's and our mufflers with a 10 year warranty on welds, pipes, workmanship & hangers for $700.00.

 

[ONEBADMK8]

What extra cost or issues ?? Its a excellent performance exhaust that is also inexpensive, with a plus in that it conveniently helps keep the drive shaft contained ???

Extra costs in buying an un needed driveshaft loop. I wasnt talking at all about exhaust in that response.