WANTED: MarkVII BBS wheels

[Blenderhead]

I'm looking for a set of the 16" BBS MarkVII wheels that look like this.

Let me know what you have, and how much shipped to a business address in 07753. Thanks.

Mike

 

[kustomizingkid]

I have a set of Crown Vic HPP wheels... look the exact same, Mustang bolt pattern. I'll sell them for $175 shipped.

 

[Blenderhead]

Are they the same offset and width?

 

[kustomizingkid]

They are 7" wide with a 6mm offset.

 

[danny_holtermann]

hey kustom, what don't you have?

 

[kustomizingkid]

A lot.... but if you need Mark VIII, Crown Vic, RX7, or Datsun Z parts I just might have it...

 

[Blenderhead]

Do you happen to know the measurements of the MarkVII wheels? The reason I ask is because these are going on a subaru and I want to make sure they fit. I have one of the MarkVII wheels on it right now, and it fits perfect, but the car is buried in snow so I don't exactly want to pull it off to measure it. If I can confirm that they will fit, I'll take them, but I want to make sure first. Thanks.

 

[kustomizingkid]

Well after searching TCCOA it looks like they are the same backspacing...

 

[kustomizingkid]

upon further research I found that the Mark VII has 23mm backspacing... the HPP Vic wheels have a slightly deeper dish, so if you can fit wheels that stick out ~1" more than the 7 wheels they Vic ones will fit.

 

[Blenderhead]

Let me take some measurements and I will get back to you. Thanks.

 

[Blenderhead]

It looks like the CV wheels aren't going to work. The Mark wheels are right at the limit of what I can fit without rubbing. Thanks anyway. Still looking for a set if anyone has them.

 

[kustomizingkid]

Damn... maybe next time lol.