myfirstls
Active LVC Member
Aloha guys. Been a while since my last post. My LS been good to us so far and no major problem thus far. But I did have squeaking noise coming from the rear end, so decided to tackle the rear suspension R&R. Had the parts for a while, but just wasn't up to it.
Anyway, pretty much everything went smooth on the right side, including removing the knuckle, but left knuckle just refuse to come apart. I'm using "front-wheel drive hub remover" (I think that's what is called) and my right came apart without any problem.
Currently, I'm doing one side at a time, so when I was doing the right side, left tire was on the ground, and since I'm doing the left side now, my right tire is on the ground. And when I used the hub remover and turn it's bolt to remove my left knuckle, it is so tight that my right wheel, which is on the ground, turn as well.
Guys have any advice on this? Did some search and my only other option seems to be remove the entire shaft assembly with the knuckle on it. gotta have easier solution then this!
Anyway, pretty much everything went smooth on the right side, including removing the knuckle, but left knuckle just refuse to come apart. I'm using "front-wheel drive hub remover" (I think that's what is called) and my right came apart without any problem.
Currently, I'm doing one side at a time, so when I was doing the right side, left tire was on the ground, and since I'm doing the left side now, my right tire is on the ground. And when I used the hub remover and turn it's bolt to remove my left knuckle, it is so tight that my right wheel, which is on the ground, turn as well.
Guys have any advice on this? Did some search and my only other option seems to be remove the entire shaft assembly with the knuckle on it. gotta have easier solution then this!