Rear Carrier Sub-Frame Bushings

[tijoe]

Has anyone replaced the Carrier bushings that are pressed into the Sub-frame?

Are stock bushings available? Has anyone found a source for Poly Urethane Bushings that will replace the stock bushings?

The attached images shows the bushing I am looking for.

 

[jmtiseo]

Not sure what would warrant its replacement but check out this thread from a fellow member.

http://www.lincolnvscadillac.com/showthread.php?t=82341

Turned out it wasn't sub-frame bushings.

*Edit - ****balls I believe you're speaking of a different bushing.

 

[tijoe]

Edit - ****balls I believe you're speaking of a different bushing.

Yep! I am looking for information on the Bushings that hold the carrier rear cover to the sub-frame.

This if for my Mark VIII IRS carrier installation on a LS sub-frame. I am concerned that if I use Poly Urethane bushings on the front mounts, it will unevenly load up the stock rear rubber bushings, causing them to wear or split.