Re&Re - OEM Auxiliary Coolant Flow Pump - GEN 1 V8

RigsLS

Dedicated LVC Member
Joined
Mar 10, 2012
Messages
7,756
Reaction score
532
Symptoms: No heat at idle and/or low RPM's

Direct Cause: Faulty worn out Auxiliary Coolant Flow Pump.

Correction: Replace Auxiliary Coolant Flow Pump with OEM part only. (p/n 1W4Z-18D473-AA)

attachment.jpg




Removal and Installation aka: Re&RE

1) Disconnect the battery ground cable.

2) Drain the radiator. * Upper rad hose should be out of way also.

3) Disconnect the connector.

attachment.gif


attachment.jpg


4) Remove the two auxiliary coolant pump to fan shroud bolts.

attachment.gif


5) Disconnect the hoses and remove the pump.

attachment.gif


attachment.jpg


6) To install, reverse the removal procedure.

icon4.gif
Make sure that the heater hoses are installed in the correct position.

icon4.gif
Lubricate the coolant hoses with MERPOL® meeting Ford specification ESE-M99B144-B or plain water only, if needed.

icon4.gif
Check for correct hose installation by verifying DATC system operation.
 

Members online

No members online now.
Back
Top