Quick question: Dash Removal *pic*

[Myco]

From my last dash removal I found this plug unplugged but can't find where it goes too? Where does it go?
Also: do I need to remove the cross-brace under the steering column? (I'm pulling back the dash to replace the heater core).

Also: Do I need to pull the cluster trim stuff?

 

[austin26372]

You'll need to pull all four nuts under the steering wheel. IIRC, they're 15mm. The front two hold in the brace. The wheel will then move down and rest on the plastic vent below.

You shouldn't need to pull the cluster trim... but it's only four 7mm bolts if you must. Two behind the headlight knob and two at the gauges.

As for the wires, not sure...