Problems starting my 98 STS p0322 code

[midnight504]

i replace the crankshaft position sensors and the camshaft position sensor and the control module and it still dont start i need help


P0322 Ignition/Distributor Engine Speed Input Circuit No Signal

 

[Valcor]

help

Did you get that figured out I have the same problem

 

[Lownslowlsc]

As in the code or "no start"?

Test fuel pressure first. If you have fp then replace the cps, then cam sensor.

 

[Valcor]

I have replaced 2 Crank sen and the cam sen and The ICM


any more thoughts

Codes

p0322 Ignition/ Distributor Speed input circuit no signal

b2711 is the pass key

b1312 Hi side temp sensor

After about 30 sec of starting it will finaily start and run after it cranks it does not stall or nothing it only does it everytime I try to crank it

 

[lincoln ls_250k]

you will need to check the wires that go to the crank sensors (this will be a bitch as there is no room behind the front manifold), make sure they have continuity all the way to the ecm if u need diagrams let me know.