Pics of my custom icebox

[D Day]

Here ya go guys! It bolts up to the 2 out of the 3 stock locations for the air box bolts. I left the bottom one out because its a little PITA. The shield

MAF and 4" adaptor

Yes, I gutted the MAF. I think I need a chip for that to work but I figure its less restrictive like this and it looks cooler

I cut the excess rubber and used it for the end of the MAF to create a snug fit.

Follows the curves of the hood

 

[Frogman]

That looks pretty damned good.

 

[Stack]

There is a gap... you gonna fix that?

Otherwise... nice

 

[D Day]

Ya, I'm going to seal it with some rubber

 

[JoeyLincolnMK8]

nice job!

 

[MediumD]

Very nice.

 

[midwestbird]

What gauge material did you use? And is it aluminum?

 

[D Day]

yes, its aluminum and its 1/16.

 

[Tractionless]

If you make some more up I am sure there is a market for em. I'll take one off your hands!!

 

[D Day]

I'm thinkin about it

 

[mmtphoto]

me too-lots of east coast traffic jams, and my fresh air setup needs help in that situation-you'd get lots of sales here.

 

[98LSC32V]

I would buy an icebox from you as well.

 

[NYC LS8]

Nice work, dude! I need to get working on one for my LS!

 

[ONEBADMK8]

Actually the name "IceBox" we coined for our cold air kit.
Yours is just that a home made cold air kit.
Nice job too, it's much easier making it one piece and bending it. You will need a brake for a clean bend but it's worth it making it one piece.
My supplier for these has been "Too Busy To Make Them" for MONTHS now and anyone else that says they will do it gives me quote with outrageuous pricing or I would be sitting on plenty.

Again nice job and good luck.