New Rotors.

Macoffutt

Active LVC Member
Joined
Oct 24, 2006
Messages
157
Reaction score
0
Location
Omaha
Well today I put on my new Hawk HPS Pad, Front & Rear, plus some EBC Black Anodized Rotors.. After everything was done, we knowticed the front & rear rotors slot were going opposite directions.. So can anyone help me out with which one is correct?

Front:
100_1258.gif





Rear:
100_1260.gif


Thanks!
 
Actually, assuming this is the drivers side of the car, they both look right.
 
Actually, that's the driver's side front and passenger side rear (you can tell by the suspension mounts). And HyeLife's right; the fronts are going in the correct direction, so swap the rears.

BTW, those are some purty rotors you got there. How does the fit and finish seem?
 
Hey I got a brake question too, Not trying to HiJak the thread, I have similar rotors and So performance pads, and my car sat for about 6 months without moving and now when I brake It sounds like its grinding, but there is plenty of pad left,is it possible that its got some crud in there and grinding into the pad a little. I will make a new thread and try and get some pics...
 
Actually, that's the driver's side front and passenger side rear (you can tell by the suspension mounts). And HyeLife's right; the fronts are going in the correct direction, so swap the rears.

BTW, those are some purty rotors you got there. How does the fit and finish seem?

Thanks guys! The rotors are pretty nice. I dont believe they will stay black always, unfortunatly, but they fit just perfect. Had no problems, minus a faulty caliper that took some cohorting to get back into place. The finish was pretty good, minus a few minor nicks or scratches. Ill take a picture today after some driving. I have a feeling that until all the black on the rotor section is gone they will look funky.. Meh! Im just glad to have brakes again! :D
 

Members online

No members online now.
Back
Top