New parts for the 4.10...... Weeeeee

[MarkVIII93]

The clutch packs came in today. Now I have everything I need. Just gotta pull the rear out and find a new cv shaft to replace one that I DIDNT BURN THE BOOT ON... I found a lower mileage gen2 in the junkyard and Im going to go rape it of parts tomorrow morning. Quick qeustion though... are the axles just c-clipped in the carrier? Its a tan colored lsc if anybody needs parts from the firewall back... theres no fenders, bumper, or hood. Interior parts may be limited also. Put in a request and Ill see what I can do.

 

[unity]

Dont forget to look for HID capsules

 

[k9t8m]

Half shafts just pop out of the rear carrier.

Check the car over pretty well, anything you think you can make a few bux on buy and sell on ebay. Floor mats, engine beauty cover, hvac controls, console, rear neon, hid's etc.

 

[Rich88LSC]

If it has a evap canister tray in good shape I could use one.

 

[MarkVIII93]

If it has a evap canister tray in good shape I could use one.

Ill try... it was stripped of the neon and hids.. The car is in great shape with no rust.. Just a bunch of hacked parts due to those quick removers that dont give a sh1t about any other parts besides theirs.

 

[slowmkviii]

don't forget the deep 36mm socket and a 3 jaw puller for the outer side of the half shaft
If the inside is tan I need the LSC floor mats

 

[MarkVIII93]

odd that they just "pop" out. lol.

 

[MarkVIII93]

If it has a evap canister tray in good shape I could use one.

Where is that?

 

[MarkVIII93]

Well. Quick little update. Im going to pull the exhaust and bring the carrier housing down tomorrow and take it to the shop.. It should be fairly easy... Im assuming that I may have to remove the outer knuckles to allow clearence of the inner cv's to be removed from the carrier... Or is it possible to compress one side's cv joints while pulling the other side with only the top control arm bolt removed??

 

[Rich88LSC]

Where is that?

Under the trunk floor.

You should be able to get the rear out by just undoing one sides

 

[chicken]

If it has a evap canister tray in good shape I could use one.

gen 1's wont have a evap tray, contact customizingkid he is making replacements

 

[MarkVIII93]

gen 1's wont have a evap tray, contact customizingkid he is making replacements

It was a gen 2 in the junkyard.

 

[slowmkviii]

Well. Quick little update. Im going to pull the exhaust and bring the carrier housing down tomorrow and take it to the shop.. It should be fairly easy... Im assuming that I may have to remove the outer knuckles to allow clearence of the inner cv's to be removed from the carrier... Or is it possible to compress one side's cv joints while pulling the other side with only the top control arm bolt removed??

If you are taking out the carrier you will only half to take top bolt out of each knuckle and one side the bottom two