exhaust diagrams/measurements

[MMAFIGHTER121]

Ok I am going to be welding my own exhaust, money is set aside, welding buddy just moveed back upstate.. all that's missing are the parts! Now I know a few of you out there have cut your own exhausts too .. I've been on youtube so does anyone know where I can find a good diagram to cut my own from?

 

[01lssport]

You should be able to use the old exhaust as a template. Just don't weld anything up until you get everything under the car and in the correct position. X-pipe should go in the same place as the stock H-pipe and so on.

 

[MMAFIGHTER121]

Yea I was hoping there was an easier way then getting under there and measuring it all out.. that's all I'm gonna buy the pre bent sections then have my buddy weld it all up for me

 

[01lssport]

Take your stock one out, really simple. I think it was only two bolts, removing four rubber hangers and remove the little cross brace.