cruise control

[topher5150]

Where is the cruise control module on a gen 2 and what is the best way to put it in the wheel well. I'm doing a cobra intake transplant

 

[topher5150]

seriously no one have any ideas

 

[unity]

I dunno, but I never moved mine. I think you do have to move yours, but for me I just found another route for the cable. On a Gen 1 its located in the passenger fender near the ABS.

Dont want to sound like an ass, but if you just followed the cable you would have had your answer in less than a minute

 

[shiryu0]

its on the same place on a Gen2........

 

[topher5150]

having trouble seeing it. how far down is it

 

[unity]

You have to remove the fender lining to really see it. The cable snakes through the fender. I really mean IN the fender!

 

[topher5150]

ok i found it now, wow, how far exactly do i need to move it

 

[unity]

Is that not a crazy long cable? LOL

Its best to leave it for now, unless you have the intake on and its ready to hook up? Then just attach and position where needed. Although space is limited.

 

[topher5150]

yes extreamly limited

 

[98CobraStarLSC]

Unless you figure out a miracle, the gen II bracket wouldnt work well for me trying to run the cruise control. i just ran the throttle cable. So even though i moved mine, theres really no need to move it. I used several cable ties to tie it closer ... you dont need to go very far.

 

[topher5150]

Off subject but still pertaining to the subject at hand. How important are those tab thingies on the back of the cross over tube