ONEBADMK8
Dedicated LVC Member
Heres the two piece shaft. See the gap?
4.10's and new driveshaft.
- Thread starter clintjw95
- Start date
htrdlincoln98
Dedicated LVC Member
Gotcha so the seam is behind the fuel tank. Cannt see it with the tank in. Must have missed this when the tank was out. So my vibration is most likly the shaft. ALLLright no need to look search any longer. 400.00 and its fixed right. I'm pullin the trans to change the converter again 3rd time. is this the best way to change with out droppin the tank.
Right on the Mark
Dedicated LVC Member
Why are you changing converter for the 3rd time? Just wondering.
htrdlincoln98
Dedicated LVC Member
first one was for a e4od and didnt fit. Then two weeks later when the (right) part came in I pulled it again and installed. What do you know this converter had the same stall as my stock unit. As you can see I was soooooo happy!!!!! I wasn't lookin to pull it again so I let the shop I bought it from rest for a while until I pushed the issue again. A new one is on the way I really hope this is the right one. If nothing else mercon V is expensive..
At least your a expert now at pulling your trans
.Do you even have the energy or will to do it again.