Search results for query: *

I have over 11v at the pass thru stud

Okay thank you. And I am pretty sure it is circuit 31 it's an 03 v6. The workbook says 30.

Ok I will check that first. I did pull back the carpet and I saw the pass thru stud, I could see some moisture on the wires in places, Also there is what looks like a 60a inline fuse on a wire that I believe is red and orange...not sure what that is.

Ok Joe I am at a stop at step 6 I believe. My next step is repair circuit 30.....is there any type of wiring diagram or any suggestions on where circuit 30 starts and ends?

So I'm hoping that one of those is what's keeping this thing from starting

Ok joe I finally chipped away enuf I've and I made it back to the car. It throws 6 codes that's it.

Hey Joe I followed the trouble shooting guide and went to the point were it ask me if there were any pats codes see section 419 01b but I cannot go to that section.

I did run another diagnostic on it and got a 1262 code for bus communication. This can be caused by the pcm on passenger side?

Also wanted to thank you. Since wandering this site i have seen how many people you have tried to help. Alot of guys with your kind of knowledge are not as quick to share. So its greatly appreciated.

Ok, i am about to head back to where the car is stranded and try again. i have a nice scan tool but dont know what i should about it. i dont want to waste your time so just a few things i can think of that you might lead me in the right direction. the car sat for 10 years. new tranny and it has...

it did throw up a b2290 code also. would any of these cause the car not to crank

its normal. comes on solid then goes off. blinks like it should when the car is locked

So I have a 03 v6 ls. Was running fine had a few dash lights on. (Abs, traction control, check engine.) Starting fine. Shut it off and when I went back to start it turn the key and nothing. I have scanned it and cleared most codes. Something is stopping me from getting power. It's not the...