Search results

Looking to sell my 2004 LSE. Just turned 95K miles, has been well kept. Nice paint and interior. All regular maintenance has been done, coils have been replaced under warranty, new rear ABS sensor, fresh PA inspection. Has aftermarket remote start. Currently has touch screen nav system...

Update, it turns out that it was a bad rear speed sensor. Even though it past the multimeter test, it wasn't putting out a good signal. Used a Snap on Solus to find that. New sensor on, and all is good!

Thanks joegr, I have, see post #7. Measured at the wheel and at the abs mod. Even placed a dummy load resister in at each tire location and measured at the abs module. All the wiring around the car looks very good, i unplugged and replugged every connection, just don't know. With the few...

Ok the codes are! From the abs module C1236, c1235, c1155, u1262. Engine codes p0500, p1000, p2106, u1039. I know what the codes are, just don't know what is causing them! HELP

Thanks so far. An update, i have checked the speed sensors with ohm meter and all seem to be OK. Did this at the wheels and at the abs mod. I get an abs light from the time i key on the car. As you start driving, the speedo reads about half speed, as you build speed, the speedo jumps to correct...

I know about the COP issues. Have been down that road! I have noticed that it goes into etc when the trac light and check message comes on. I've also had a "check trans" message thrown in there for good measure.

ETC failsafe. I left the full list of codes at work. Plugs about 18 months ago after dealer replaced two coils under warranty. The abs light is on from key on, trac light takes awhile. ETC mode is hit or miss. Drove it three times after work, first drive ETC mode, second no ETC, third was back on.

A few days ago, the abs light came on shortly followed by trac light and the message center telling me to check both. The engine now also now goes into failsafe mode. I have noticed that the spedo now flux from true speed to slower than true. I had codes pulled and i have a list! Both rear speed...

Hello, did you ever find a fix for this issue? My seems to be doing the same thing. Thanks

I did end up with a new PCM. I think water got into mine. Then the coils went!

Good day, or not! I have a problem, and hope someone can help! A week ago a started getting a random ETC failsafe mode, now as soon as you turn the key it is in the mode at start-up. I am getting the codes above about the electronic TB motor/circuit. I have read about the coil interference...

Thanks for the post. Just got back from dealer. They did move around coils and plugs. said they pinned it to the #6 injector not firing from the computer. He did not say they swapped injectors. didn't get to talk to the tech, only desk guy! I didn't get to bring it home (no ride). update, Its...

Ok, i'll try to put all the info in i can. Finally got the LS that i always wanted, gen2 LSE. Had it about 1 month and started to get mis / hesitation. This is my second LS so I am aware of their bugs and problems. When I first got it home I checked the coils and found that 2 had been replaced...

Ok. One person, thanks for that. Still can't determin if this is surface or in the pastic!

Hello all, my new LS has what i thought were dull, oxidized headlights but after looking at them with the lights on, has factory HID, it all most looks like they are cracked in a billion tiny pieces! (they are not cracked) Has anyone seen this effect before? I have used the sand and clear method...

Hello all! Just got myself a 2004 LSE over the weekend. I did have a 2000 LS V8 a few years back but traded it for my wife's car. This '04 is everything i wanted my 2000 to be! Hope to pick all of your brains, i have lots of ideas. :D