Search results for query: *

Nice mark.trans is jmoded 4.10 gears posi.107,000 miles nice car.some clear coat peal not a lot.very good tires .Green with Grey interior. Air ride works sensor lowered. Front bags leak a little.$2000 obo

my town car shows no speed or odometer. I replaced the speed sensor in the trans no luck. any ideas?

Where is the vent selanoid located on the compressor assembly. I am jacked up high and cant get it down.

I am not sure if this is the problem or not. I have lost my speedometer which is analog and I have lost my odometer which is digital ,is this dashboard related or speed sensor related it is on a 1999 Lincoln Town Car.I have also lost all of the functions on the right side like miles per gallon...

I am searching for the best sounding muffler for both interior and exterior sound. I can't stand the sound of the interior drone that I have now, I have factory exhaust manifolds with no cats and true duals ending at flowmasters .Any suggestions?

I took the bolt out of the speed sensor in the tranny but I cant get it out ,Help

Looking for drivers side rear knuckle assembly, and drivers side axle shaft..

I have a 1999 town car and the code for the door key pad is on the right trunk hinge, I also have a 1998 mark viii but dont know where they hid the code. Any ideas?

I have a 2004 deville with a door lock not functioning. Do I have to replace the whole locking mechanism or just the power lock actuator

My mark wouldn't start today after sitting a while, starter wouldn't pull in just clicking.I put it on charge for about an hour, opened the door, no light, turned the key nothing,no idiot lights no clicking, nothing at all. HELP

Daes anyone know what kenny bell SC was used on that car. I've been talking to someone at kenny bell but they haven't been that helpfull. I think it's a 96-98 cobra , can anyone confirm for mr?

I saw this mark on ebay,I think those are mustang gt wheels.This would mean a hub swap yes?

What is the best way to get low end hole shot torque out of the mark viii? I have put in 4:10 gears , jmod and an sct tuner preformance tune. I just think there is more there somewhere.

Is anyone on here running nitrous? if so what brand kit and what kind of results.Just thinking about a project.

I have a 98 gen 2 ,can I swap out the intake from a gen 1 or is it a big mess.

I purchased a 1998 mark viii, got the air ride fixed then started the mods.Deleted all cats,2-1/2"dual exhaust,intake silencer delete,4:10 gears,jmod and an sct tuner with a tune from Torrie at unleashed tuning.all this work is wrapping up just as winter sets in,so now i'm anxious about the...

Are there any vendors that sell a predrilled jmod plate,I found some vendors that did sell them but stopped.

What grade are the 50mm torx bolts that hold the knuckle on to the lower control arm? Also what is the reason for the torx bolts,can we just use the proper grade bolts with washers and nylon locking nuts?

Ok so I removed the 36mm crush nut and now I can't get the axle to break loose. Yes I did try a sledge hammer , any suggestions please.

When the solenoid vents air my front vents down, should the rear vent also?