Here is the most helpful of them for finding out the wiring on the GEN 1 model. Next, we still need diagrams for the GEN 2 model. Still need to know which wires are for the puddle lamp and which are for the LED Turn signal. But ultimately which wires are going to adapt to the GEN 1 harness for...
Here is the 1993-96 Lincoln Mark VIII Electrochromic Mirror Wiring Diagram that shows wires for the heater in the driver side mirror.
[/URL] Uploaded with ImageShack.us[/IMG]
This is the electrical wiring for exterior lighting on 93-96 Mark VIII's. I tried to color code best I could. I have more diagrams to color code and upload, stay subscribed to this thread and I should have them all up soon. I am working to get more of the 97-98 Diagrams but it is really hard to...
I'm doin the same project. I am goin to post some schematics and try to color code them for easier reading and to help others that might not be as good at wiring.
I am going to attempt to upgrade my 1994 Lincoln Mark VIII intake manifold IMRC setup. Well, my friend will be doing it because I'm not very mechanically inclined yet. I'm trying to become familiar with the process so I can help and also make sure I have everything for the project.
I have...
My CarPC
Yeah I took off my A-Pillar and took out the electronics for the old mic system. I wired in a mic in the same position and am using the same stock button to initiate calls. It hooks up to my CarPC's MIC IN jack. And my phone is connected through bluetooth to my USB Bluetooth...
HID Housings
I want some HID housings for my '94 too. Any ideas where to get them? And I will hit you up for these plates/adapters after I get the housings.
Seafoam
Oh man, yeah so I ran Seafoam through the gas tank and wow. My car finally runs well again. no more 500RPM idle. I'm at about 800 now. And my acceleration doesn't stutter. Thanks alot. I never knew you could run it through the gas tank. I only ran it through the PCV. My co-worker also...
EGR followup
Well actually I replaced the EGR tube/Pipe. I had that old whack one that breaks when you do transmission work. You know the one with the flex pipe. Replaced only that. Should I replace the other EGR components you suggested too?
Also, I took your advice on checking the intake...
Amp
Yes it is a car audio amplifier. I think what is throwing you off is the multiple wires hanging off of it. You can get rid of the wires and still use it. Unless you have the connectors that plug into the sockets. But, yeah it doesn't lok like a very good amp. It looks like a 2 ch 200watt...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.