I had to change the filter drier o rings beginning of the year cause it all leaked out, so then I put in 3 small cans, I can't remember for sure might of been 2
Way in the red. I know this a separate problem but before if I set my auto temp at like 70 my ac would work for alittle bit then my heater would start blowing. And it would be just hot air and it won't blend at all. Is this natural.
The car was running with my ac on and the compressor was kicking on, I only have the low side gauge. I checked it when it was running. The pressure was extremely high so I never run my ac or defrost. I don't want to ruin my compressor.
The whole summer I had ac just fine, then at the end of the summer is slowly went out, now it shows it has too much freon/ pressure in system. I figure I have blockage, or a bad pressure switch. Any ideas? Where should I start?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.