Recent content by Markus2

http://newyork.craigslist.org/wch/cto/2109261926.html Make me an offer-I just am fed up. Compression checked out fine. So did vac. and fuel pressure. ..IT STILL HAS AN UNSTEADY IDLE (roll of about 50 rpms) (i think its wiring) take a look at the post if any of you are interested. I...

update. had to add a quart of oil today-very dark and around one quart low. oil change is due- its around 2500 since last... oil is very very dark. more clues to the mess that is a mark vii

gasket aint leaking...it is def. not leaking.

manifold gasket was replaced at same time of headgasket. I will check never the less. Thanks for insight Its just so odd how smooth is runs for the first few minutes...

i found it 1987 Dodge Charger GLHS SHELBY This vehicle is for sale on ebay. STOCK OUT OF FACTORY BY FAR THE COOLEST EVER. TAKE A LOOK AT THE SPEEDOMETER. WRAP AROUND NEEDLE 360 degrees so cool

in deep.. i hear ya man... ... ..... i have said it before but am strongly considering... im in deep with this mark. by far the most invested in respect to other vehicles in the past. 96 mustang gt-(4.6 modular) from 59k-115k. only thing i ever replaced was alternator. 91...

missed my mark on my mark :( NO SUSPENSION CODES. Thought maybe I did something wrong because it was the first time I used my new scanner I got off amazon. Brought ride to mech. STILL NO SUSPENSION CODES. I told him the light went on and there should be a code. He said the...

update. The belt was routed wrong. I do have the performance suspension. Im a dumby. I should have just figured that the LSC SE- (top model at the time) would have the performance suspension. I just never have had to think of that option before. So i currently have a pump specified...

update. Checked timing again... like you guys said... It had been reset by mechanic when ignition module was installed.. so idle became STEADIER after install but backfiring underhood was occuring... So i show up unannounced at mech. shop and told him the timing was off. He...

Timing is most definately at 0 will bump it up-and report back. Like I have said but still not done.... vacuum @ idle is 17-close to dead steady- AS STEADY AS I HAVE SEEN IT. You really think the distributor could be the issue if it has the flat spots, like hickups, when im driving along...

ford man thanks again for input. I think the arm is pointed down at more like a 5 oclock shadow. Went back to the NEW mechanic (another mechanic I will never use again) and told him that I thought it was shady that they told me I needed a shorter belt after using the same pulley. They...

so... i kept going over in my head this predicament with the belt squeal after the power steering pump install. I have looked over everything again and again... and it seems like the belt tensioner up top, has its arm in an EXTREME downward position. I think the belt might be routed...

If more than one part(s) for our mark vii's specifies: With or With Out Special Handling. With or With out Handling Package. I think it mite be important to know. Does anybody on here know what those options are and how to tell what my 91 SE LSC has stock? Is this only related to...

Installed power steering pump specified for mark vii without handling package. I still have no clue what that means if anybody does??? ????? ??? ?? Seems to be working fine however I have horrible belt squeal when in park and i rev it. and sometimes as i drive from a complete stop to...

I will examine the distributor when I bump up timing later in week. I really think that my timing was fine when i bumped it up a while back and had to run the 91 -93. Than after the ignition module my mech. set it back to zero and wanted me to drive it like that-That day it ran smoother no...