Can anyone tell me the height of the frame rail to the ground at the front crossmember ? Engine is out of the car so I can’t exactly get a good measurement at ride height.
Can anyone tell me the height of the frame rail to the ground at the front crossmember ? Engine is out of the car so I can’t exactly get a good measurement at ride height.
Back to this thing trying to figure out long tube headers. 3rd set might would’ve been close enough to modify except I think they screwed them up slightly, lol.
I can confirm flowtech 12157FLT long tube headers will not fit, even on the passenger side where there is ample room. They hit the motor mount and steering rack fitting. Still open for suggestions
Planning to tackle the exhaust next. Anyone have any advice on long tube headers that clear the steering, and actually fit the channels underneath the floor pan?
Here’s the 4” aluminum driveshaft mocked up. It’s very tight but fits. Nothing touches, but will need more clearance around the center bearing carrier mount.
Quick update. Finally getting somewhat sorted on an aluminum 1 piece driveshaft for my ls engine/6l90 swap. Found a dorman replacement for a Silverado the correct length, just waiting on a conversion u joint. Not sure if I will have to cut the center bearing support for this 4” diameter...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.