Recent content by fastmarkviii

http://www.cardomain.com/ride/2221012 (my cardomain.) about $9000 into the car im getting rid of it b/c of school reasons. Selling for $2900 obo. Loads of new stuff in it, fun car, lsc 1995 blue. ask for details. Im in palm bay florida, call me on my cell ~ 321-501-9515 or email me ~...

where do they sell the body kits for the mark??????????????

So can I order 1 today?????????

No No No No No No..............

so how much does a abs sensor usually go for?

So can no one help us on this matter????????

$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$yup I did that durning the hurricane and had to change the engine, you can try taking the plugs out and getting a socket on the crank w/ a fence pole or breaker bar for torque and try to push the water out, I bent my rods lesson to...

well keep the post in the front this is an important 1!!!!!

after I did my lower control arm today my abs light turned on, I took the battery cable off and left the key on to try to reset it but it didnt work,,, while I was changing the control arm I noticed the other line to the caliper (not the fluid line) was very extended..... any ideas?????????

It was honestly not too too bad it would have been a breeze if I had known what I just posted on this thread greatly, it would have def. saved about 2 hours no kidding.... plus if I wasnt doing it by myself, always get someone to help is the rule but sometimes u just have to ruff it

make sure if you only have a normal set of sockets to also buy a 15/16 ths deep socket, and rent a ball joint remover(the fork type) this will prevent you from having a 4 1/2 hour change out, also if the ball joint starts spinning while u try to turn the nut on it get a jack and jack up the...

I would have to say dont get them, there is a brand called wired wheels and they have a wheel that looks very similar and everyone and there mom has them, so unless u wanna have a wheel that looks like alot of everyone elses..... try to go for an original look, good luck post pix of whatever u...

Its so exspensive with the timing chains b/c its a really big job too, I guess what I have to do is wait until it blows than try to get a 99 cobra engine from ford installed

What Ball Joints?

hhmmm ball joints?