Recent content by Antony

I will give that a try ! Thank you.

Tried that, but thanks for the help.

Had rough idle with my 2003, after throttle body, coil overs, new plugs, 02 sensors, I found that my injectors were bad. had it in the dealership a couple of times and they did not even figure it out, they said it was throttle body( hence the replacement). so , if you have not replaced them...

2-9-2022..... one week ago I swapped parking places with my truck due to the snow we were going to get, went out the next day to start car and key would not turn ignition switch. flipped key over and still no luck. got second key set and still ignition would not turn. is there some king of lock...

I have not pulled the lower intake, that will suck if I have to go back and do that. will check the elbow you are talking about though.

Thanks for your info, have replaced all of this with motorcraft parts. not much that I have not replaced on this. will double check though as this stuff is subjected to a lot of engine heat due to everything being crammed together tight on these engines and engine bay.

double checked that before reinstalling intake, just because it is a pain in the ass to remove everything to access plug and coils. had codes pulled. showing O2 sensors are not functioning properly. will be replacing those Tuesday.

Getting ready to do just that. lol It would be quicker.

Tasca Ford is Great. noticed a lot of stuff for 2003 is getting thin.

Own an 2003 Lincoln LS with 3.0 V6 engine. Has 176,000 miles and is well kept.