Recent content by 97Towncar-4R70W

It also happened to me with my 97 Towncar, but I put it back thus it is a "SPLASH SHIELD" and it have the benefit to shield rain water on the road, specially when you hit some road areas with 1, 2 or more inches of water deep splashed into the engine compartment and wet the serpentine drive belt..

My 97 Towncar ac blend door actuator started making a clicking noise for several moths until it stop blending the air, caused by internal failure of the plastic gear drive that is controlled electronically inside the "Blend door actuator" that positions the heater blend door in the right...

By the way. I went under my car again and removed the entire fuel pump module with the fuel level indicator switch that is attached to it as a combo unit. Performed an outside resistance check on the fuel level sending unit and it was within the following parameters: 19 to 20 ohms when the float...

Towncar Sending Unit Stuck Yes Guru, you hit it. I also experienced the same condition on my 97 Towncar thus my fuel gauge is stuck showing always 15 gallons regardless of fuel level, or so I suspect, thus I replaced the fuel pump motor without dropping the fuel tank and the space to R&I the...

Digital Speedometer I have no prior bad experience with VSS, but I suggest you first check your VIN # for Cruise Control problems that Ford was having affecting many of their cars product lines, including Lincolns.... . Then look for any stored Fault Codes? as you know, a VSS is a magnetic...

You may also like to consider that some 92-96 vehicles came with a TCC of low resistance value (1.0 - 3.o ohms), while others came with a TCC with a 10-16 ohms value. If the wrong TCC is installed, it may not allow the converter clutch apply, or to erratically work. Also check the EPC selenoid...

I SWAP my 97 TRANS FOR A 98

There you go... that will also work..!:)

OK.. so I went back to my garage with a new attitude to never give-up and after several different attempts, I was able to resolve and pulled out that Starter 3rd bolt. This was How: Assembled two- 3/8" extensions + 1- 10mm 6 side socket adding 6" in total lenght. I inserted the first 2 parts...

Thanks for your input.. yes.. that would be a way.. the thing is how to get the tools inside that restricted area and be able to turn the handle on the wobbles?..This is killing my drive..jajaja.. will see...thus I refuse to throw down the towel.....!

I will appreciate any information on how to get and remove the top 10mm bolt that holds the Starter on a 4.6 V-8 Lincoln Towncar. The other 2 bolts are reachable from underneath the car. I dont know if the top bolt could be reached with a Restricton 10mm Wrench (a curved wrench in the shape of...

I used tape also to hold the glass on a broken cable regulator on my 2002 Malibu-Rh Rr door, but tapes will aventually give-up and if you hit a road bump or so, the glass will slide down partially . I overcomed that by placing a piece of wood beam made from 1"x 3/4" and custom cut to the exact...

Well, the regulator designs is more or less based on the same principle, that is: Cable operated by means of an electric motor winding up the cable on one side and releasing it on the other side into a spool inside the gear case. This will make to cable, that is attached to a slider in the...